سؤال قراءة ستيب محلول — فهم التفاصيل (تدريب 7097)

Along with clocks, watches are the most common devices for measuring time. (2) Watches were developed later than clocks. The first portable timekeeper or watch was produced during the Renaissance. A weight and a crude escapement were suitable in clocks but could not be used in a portable watch. In the early 1500s a coiled metal spring that transmitted energy as it unwound was substituted for the weight. By the 1580s, about the time of Galileo’s pendulum experiments, the first commercial watches were being produced in small quantities in Nuremberg (Nunberg), Germany. Known as Nuremberg eggs, these early watches were portable but had only an hour hand because the escapement mechanism was too inaccurate to show minutes. (3) The English physicist Robert Hooke, who introduced the basic pendulum and escapement mechanisms in clocks in the 1660s, applied the same idea to watches. He attached a small balance unit to the mainspring unit. A balance spring, or hairspring, was used to control the oscillations of the balance unit. This design formed the basis foe all subsequent mechanical watches. (4) The mechanism of mechanical watch is made up of six different parts. These are the mainspring, which is the source of energy; the gear train, which transmits the energy; the dial train, which governs the movement of the hands; the winding and setting mechanism; the escapement and balance unit, which controls the release of energy; and the plates, or framework, which enclose and protect the movement. (5) In operation the mainspring unwinds to turn the barrel, which drives the escape, or great, wheel through a gear train. The wheel moves in one direction until stopped by a pallet arm of the pallet and fork – the part analogous to the detent of a clock. The pallet and fork assembly is attached to the balance wheel, which is then given an impulse from the escape wheel. (6) The escapement and balance assembly are essential to an accurate watch mechanism because they control the release of energy from the mainspring and the time in which each release of energy is made. The oscillations of the balance, regularity of its movements, are controlled with a hairspring or escapement spring. When the balance wheel moves in one direction, its tiny hairspring is wound. As the escape wheel is stopped by one of the pallet arms, the hairspring uncoils. The balance wheel, in turn, is connected to the coiled mainspring, which winds as the balance wheel moves. When the pallet and fork assembly releases the escape wheel, the wheel rotates one tooth until caught again by the other pallet arm. The balance wheel then turns in the opposite direction until the other pallet arm stops the escape wheel. This cycle continues and causes the familiar ticking sound of the mechanical watch. The escape wheel is stopped and released every one-fifth of a second. Thus the balance wheel swings back and forth 300 times a minute, or 432,000 times a day. As in a clock, a series of gears transfers the motion of the escape wheel to the hour, minute, and second hands. (7) Electric-powered watches use one of three drive systems: (1) the galvanometer drive, consisting of the conventional balance-hairspring oscillator, kept in motion by the magnetic interaction of a coil and a permanent magnet, (2) the induction drive, in which an electromagnet attracts a balance containing soft magnetic material, or (3) the resonance drive, in which a tiny tuning fork (about 1 inch [25 millimeters] in length), driven electrically, provides the motive power. Both galvanometer and induction drive types use a mechanical contact, actuated by the balance motion, to provide properly timed electric-drive pulses. Each oscillation of the balance operates a time-indicating gear train by advancing a toothed wheel one tooth. What starts the movement of a watch?